Hello,
I am hooking up an EVO-ALL to operate my OEM remote starter via a CARLINK ASCL6. I am also attempting to add a shock sensor and blinking LED. I am using t-harness THAR-FORT4.
It took quite a bit to get the ASCL6 to talk to the EVO-ALL. I could only get it to "talk" by sending a lock command during the learning process. For some reason I did it on a whim after trying all sorts of plug combinations etc.
However, now it has no confirmation of the commands it sends. It send 3 separate pulses for the lock and unlock commands. I had to wire the Lock [(white/black) to BCM (blue/green)] and Unlock [(white) to BCM (yellow/violet)] for the lock commands to send. Why am I not getting a status reading? Do I have to wire the Driver Door Pin?
I thought this would be mostly plug and play, but it seems like there is some wiring that needs to be done.
Also, LED is wired to 12v+ and negative to white wire on the 20 pin but it is not working. I also have a shock sensor on the way and need help with that. I've been at this for 3-4 days off and on. Programmed as standalone remote start and EVO alarm via Flashlink. HELP!
Thanks
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
